If the scanner beeps instead of flashing, then you’ve entered the frequency somewhere else. Once the display flashes, you’ll know that you entered the frequency correctly. To save your frequency, press the “E” button on your after entering the frequencies on your device. Remember, you’ll have to use the number pad and decimal to enter in your frequency correctly. Just like you would with a standard police scanner, you’ll want to start entering frequencies onto the handheld scanner. This means that it is ready to start programming channels.
Most radio devices have the words “CH” on display. Then, you’ll want to press the programming button, or you can hold down the button, and it will appear within seconds. Once you’ve found the programming button, you’ll be able to start saving channels into your radio. If you’re looking for an advanced model, check.
Topeka police scanner manual#
Either look at the user manual or ask the retailer to show the difficult area. Depending on your police scanner model, it might be labeled “PGM” or “Prog.” The button might be located in certain places. Next, you’ll want to look for the programming button. It’s normal sound when searching for the right radio frequency. Since you haven’t programmed local frequencies, don’t be alarmed when you hear white noise. Make sure to turn it on to ensure that there are no problems.
Connect the EquipmentĪfter finding your desired frequency, its time to connect the scanner and the antenna. If you want to find local frequencies, you should look online for the information, or ask the retailer where you’ve previously purchased the scanner. Check your radio and see if it has the frequency range needed for your desired police channels.